Radio Shack 7-in-1 Remote Control with Lighted Keypad Uživatelský manuál stáhnout pdf (Strana 19)

Need help? Call

1-800-989-4706

from a VCR’s original remote control, press

PLAY

on the 7-in-1.

If the key you want to program is already

used for another command, press

SHIFT

before pressing the key. For example, to

store the command SHIFT-PLAY, press

SHIFT

then

PLAY

on the 7-in-1.

7. On the original remote control, hold down the

key that you want your 7-in-1 to learn until

the red light on the 7-in-1 blinks once.

Note:

If the command was not programmed

properly, the red light blinks for about 3 sec-

onds then turns off. If this happens, repeat

Steps 4–7.

8. Repeat Steps 1–7 to store more commands.

9. When you finish, press

ENT

on the 7-in-1 to

save all stored commands.

Note:

If you do not press a key within 15 seconds,

the red light blinks for about 3 seconds then turns

off. Begin again from Step 1.

Clearing All Commands

1. Hold down

SET UP

on the 7-in-1 until the red

light above turns on.

2. Press the device key on the 7-in-1 for which

you want to clear all commands. The red

light blinks once.

3. Press

LEARN

on the 7-in-1 twice. The red

light flashes for a few seconds.

4. Press

SET UP

on the 7-in-1. After a few sec-

onds, the red light flashes then turns off.

15-1924.fm Page 19 Monday, July 19, 1999 12:50 PM

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Komentáře k této Příručce

Žádné komentáře

Radio Shack 7-in-1 Remote Control with Lighted Keypad Uživatelský manuál Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Ostatní vstupní zařízení Radio Shack 7-in-1 Remote Control with Lighted Keypad