Radio Shack 6-in-1 Remote Control Provozní pokyny stáhnout pdf (Strana 3)

ote: The REC button must be

pressed TWICE to record from

your VCR. For some brands of

VCRs, you might need to press

he REC button once, then press

t again for three seconds.

Set Up Battery Installation

n the back of the remote, push

own on the tab and lift the cover

off. Match the batteries to the

and - marks inside the battery

case, then insert 2 AAA Alkaline

atteries. Press the battery cover

back into place.

Battery Saver

Your remote automatically turns

itself off if the buttons are depressed

for more than 30 seconds. This will

save your batteries should your

remote get stuck in a place where

the buttons remain depressed

(e.g: between the sofa cushions).

Code Saver

Codes are stored in permanent

memory while you are changing

batteries so you will not lose any

codes stored in the remote while

you are changing batteries.

Power-On Default

The remote powers on in TV mode.

Code Search

If your product does not respond after you have tried all the codes for

your brand, or if your brand is not listed, try searching for your code

by following these steps.

1. Manually turn on the device (TV, VCR, etc.) to be controlled.

2. Press and hold the SET UP button until the red indicator stays

on, then release the SET UP button.

3. Press and quickly release the desired mode button (TV, VCR, etc.).

The red indicator blinks off once.

4. Press the PROGRAM UP button repeatedly (up to 300 times) until the

device to be controlled changes channel. The red indicator blinks off

wit

h each button press. If you accidentally overshoot the code required,

ess the PROGRAM DOWN button to backtrack through the library

until t

he device changes channel. Pressing PROGRAM UP changes

dir

ection t

o f

ward again.

5. Press and release MUTE to install the code.

Most users will store VCR codes under the VCR button, Cable codes under

SAT/CABLE, etc. If, for example you want to store a VCR code under

SAT/CABLE, first follow the procedure for Direct Code Entry

and pr

ess SAT/CABLE in step 2 of Direct Code Entry, then enter any

VCR code in step 3 of Direct Code Entry. Then follow the steps above

for Code Search. Note: If the device does not have a PROGRAM UP button,

use PL

Y (VCR only) or POWER instead. Code Search starts from the

currently stored four digit number under that mode.

1 2 3 4 5 6 7 8

Komentáře k této Příručce

Žádné komentáře

Radio Shack 6-in-1 Remote Control Provozní pokyny Strana 3

Komentáře k této Příručce

Související produkty a manuály pro Dálková ovládání Radio Shack 6-in-1 Remote Control