Radio Shack Invisible Beam Entry Alert Uživatelský manuál

Owner’s ManualPlease read before using this equipment.Invisible Beam Entry Alert

10Installation4. Remove the protective paper from the adhesive strips onthe back of the reflector and press the reflector onto theother half of the br

11Installation2. Turn SENSITIVITY clockwise to MAX. If the alignment is cor-rect, the ALIGNMENT INDICATOR lights. The indicatorturns off when the beam

12Installation• The alert might not detect a broken beam if you walknear the alert. If this happens, walk away from the alertto see if the ALIGNMENT I

13Installationswitch to ALARM, the external siren sounds when the beampath is interrupted.Caution: The external siren sounding device must be rated at

14InstallationConnecting Another External DeviceYou can connect another external device (such as a phone dial-er or an alarm system) instead of an ext

15Installation5. Connect the other end of the wire to the external device.Refer to the instructions in the external device’s Owner’sManual to confirm

16OperationˆOperationUSING THE ALERT1. Loosen the screw on the door on the side of the alert, thenopen the door to expose the sensitivity and mode swi

17Troubleshooting4. The built-in buzzer sounds and/or the external siren, dialer,or alarm system is activated.5. To conserve the backup DC source’s po

18CareˆCareModifying or tampering with the alert’s internal components cancause a malfunction and might invalidate its warranty. If youralert is not p

19Care3. Press down on the top of thecover near the tab, and removethe cover.4. Remove the fuse by pulling thered ribbon.5. If the fuse is blown, wrap

2WARNING: To reduce the risk of fire orshock hazard, do not expose this product to rainor moisture.CAUTIONRISK OF ELECTRIC SHOCK. DO NOT OPEN.CAUTION:

06A01 AO0054ABA149-312 Printed in ChinaˆSpecificationsApproximate Effective Distance ... 2.7 to

3ContentsˆContentsFeatures ... 4General Information ...

4FeaturesˆFeaturesYour RadioShack Invisible Beam Entry Alert projects an invisi-ble beam of infrared light across an area you want to secure.With your

5FeaturesPower Failure Alarm — triggers an external device when bothAC power and a backup DC power limited source (if one is con-nected) are off.GENER

6InstallationCaution: Home security systems require a permit in some ar-eas. Check with your local law enforcement agency before youinstall your syste

7Installationalert, you can adjust the reflector angle up to 10° from centerand adjust the beam lens up to 10° vertically and 5° horizontal-ly. You ca

8InstallationMOUNTING THE ALERTYou can mount the alert on a wall or on a desk using the sup-plied wood screws.Notes: • The supplied screws are suitabl

9InstallationOr, follow these steps to mount the alert on a desk.1. Place the alert on a desk and use it as atemplate to mark the position of the twos